B) Taking The Device Into Operation - Conrad Visiondrive Bedienungsanleitung

b) Taking the Device into Operation

Plug the cigarette lighter plug into a matching plug of your vehicle. With the sup-
ply voltage applied, the car camera will immediately start reading in the basic con-
fi guration from the SD card (initialising). The display briefl y shows the home page
"Visiondrive ". The GPS LED is lit red. Once initialisation has been successfully
TM
completed, the car camera greets you with an English welcome text: Welcome to
Visiondrive , your partner for secure driving. Have a good drive. Audio mode is on
TM
or off.
☞
The greeting text and the confi rmation texts for the selected functions are
output in English by the car camera and cannot be switched to other lan-
guages. Any other operating steps are explained later in these operating
instructions. Please also observe the following items in these operating
instructions.
Never interrupt the voltage supply during initialisation because this may
cause damage to the software. If the motor of your vehicle does not start
up at the fi rst attempt and your car camera is still initialising, wait before
trying to start up again.
During operation, the SD card must never be removed because there
may be irreparable loss of data. Always wait for the car camera to com-
plete data fi nalising after disconnecting the car camera from the vehicle
power supply. Once data has been successfully stored, the GPS and
REC-LEDs go out. Now you may remove the SD-card.
67