Safety Notes On Mechanical Installation - Conrad Visiondrive Bedienungsanleitung

7. Safety Notes on Mechanical Installation

• Any changes in the vehicle that become necessary for the installation of the sys-
tem or other components must be carried out in such a way that neither traffi c
security nor the stability of the car are affected.
• With many vehicles, the type approval will lapse if you merely saw out a section of
the sheet metal.
• No parts must be installed in the airbag trigger area because this may cause injury
to the vehicle passengers in case of accident.
• If there are any doubts regarding selection of the installation site, inquire for infor-
mation from your car vendor.
• Before drilling the bores, make sure that no electric cables, brake lines, the fuel
tank or similar are damaged.
• When using tools to install your system, observe the tool manufacturer's safety
information.
• When installing your system, take into consideration the risk of accident which can
arise from devices being torn away in case of an accident. Therefore, you should
secure every component in a place where it cannot be dangerous to passengers.
☞
These installation instructions do not apply for all vehicle types. Due to the
great number of car brands and car models, the following assembly steps
are meant as general guidelines. For vehicle-specifi c questions, contact
your car manufacturer or a specialist workshop for your car model. Check
the car-related laws for your specifi c country to see if installation, installa-
tion site and use of this system are permissible.
59