Operation Of Base Station; A) Selection Of Temperature/Air Humidity Sensors - Conrad 64 61 09 Bedienungsanleitung

11. Operation of Base Station

a) Selection of temperature/air humidity sensors

Press the "CHANNEL" button briefly to change between the built-in temperature/air humidity sensor
and up to three outdoor sensors.
For the internal sensor there will be "IN" on the display and for the up to three outdoor sensors (one
included in delivery) the corresponding channel number.
If no data is received by one of the outdoor sensors, there will only be lines (eg "--.-") on
the temperature and air humidity display, instead of a reading.
It is possible that the base station is receiving the radio transmission data of your
neighbour's sensors. This can cause reception problems in your own temperature/air
humidity sensors. In this case you should change the transmission channel on the
temperature/air humidity sensor.
If the temperature or air humidity ranges are above or below (see "Technical Specifications")
there will also be lines shown on the display (eg "--.-").
Next to the display for temperature and air humidity you will find a tendency display which shows you
the tendency, where the readings will go.
Increasing
TREND TREND
Left to the air humidity display the so called comfort indicator is shown:
Display Temperature
DRY -5°C to 50°C (23°F to 122°F)
☺
COM 20°C to 25°C (68°F to 77°F)
WET -5°C to 50°C (23°F to 122°F)
64
Steady
TREND TREND
Air humidity
Below 40% RH
40-70% RH
Above 70% RH
Decreasing
TREND TREND