Care And Maintenance - Elite ARION MAG AL13 Bedienungsanleitung

13) Do not use the bicycle brakes to stop. Rest a foot
on the ARION MAG ALU frame and allow the bicycle
to come to a stop.

CARE AND MAINTENANCE

1) Prolonged sun exposure may deform the roller.
Do not use or keep the roller to direct sunlight.
2) Always clean the rollers after use. Only use a damp
cloth. Do not use solvents or harsh detergents.
3) If the ARION MAG ALU is not going to be used for a
prolonged period, release the drive belt, bringing it out of
its seat, or close it, otherwise the belt's tension could
cause early loss of transmission efficiency.
4) The coupled bearings on the roller do not require
lubrication and are practically maintenance-free.
5) Periodically check the roller clamping screws, make
sure that they are still tight but not so tight as to damage
the plastic frame.
6) In case of wear or breakage of the drive belt, replace
it by proceeding as follows:
A) Remove the rectangular covers (C) from both front
longitudinal members (with aid of a screwdriver if neces-
sary), and the screws and washers from the front roller
on both sides, using the Allen key I) supplied.
B) Undo the fixing screw (Fig. 16).
E
C) Undo the fixing screw located on the longitudinal
member on the side opposite the magnetic resistance
of the middle roller F) (Fig.17).
15
I
16
A
F
D) Replace the belt, refit the rollers in their correct
seats and secure all the screws again.
E) Position the rectangular cover on its seat.
7) Drive belts and other spare parts for the ARION
MAG ALU are available from you local Elite dealer.
IMPORTANT
1) Read and follow the enclosed instructions.
2) Keep people, children and animals away from the
roller during use, since the moving and rotating parts
of the roller and the bicycle can cause damage in
case of contact.
3) Before starting training, position the trainer in a dry
place, away from potentially hazardous objects
(furniture, tables, chairs, etc.) in order to avoid any risk
of inadvertent or accidental contact with them.
4) Make sure any unevenness in the floor or objects
present on it cannot come into contact with the
rotating components of the incorporated mechanical
resistance.
Technical assistance:
Fax 0039 049 5940064
e-mail: contatto@elite-it.com
A
I
17
EN
15