Maintenance And Care; Replacing The Rotor Blades; B) Replacing The Tail Propeller - Reely Rex-X Nano Wichtige Informationen


11.

Maintenance and Care

Clean the exterior of the model and the remote control only with a soft, dry cloth or brush. Never use abrasive cleaning
agents or chemical solutions as these could damage the surfaces of the casings.
a) Replacing the Rotor Blades
Observe the rotational direction of the rotor when re-
placing the main rotor blades.
The rotor blades of the upper rotor are marked "A", the
rotor blades of the lower one "B".
Do not overtighten the fastening screws of the rotor
blade retainers (also see figure 6).

b) Replacing the Tail Propeller

If required, the tail propeller (1) can simply be pulled
off of the motor shaft upwards manually.
When putting on the replacement propeller, ensure that
the propeller is not skewed which would bend the mo-
tor shaft.
Regularly check all screw connections of your helicopter for tight fit. All moving parts have to be easily movable but
there should not be a clearance in the bearing.
When replacing mechanical parts use only original spares available from the manufacturer.
The spare parts list is located on our Internet page www.conrad.com in the download section to the respective product.
You can also order the replacement parts list by phone. For contact information, please refer to chapter "1. Introduc-
tion" at the beginning of these operating instructions.
Figure 13
Figure 14
37