Inserting And Changing The Batteries - VOLTCRAFT ET-02 Bedienungsanleitung

lines, use a clean, lint-free, antistatic slightly damp cloth. Allow the product to dry completely before you
use it again to conduct measurements.

Inserting and Changing the Batteries

Operation of the meter requires six mignon batteries (AA). You need to insert new, charged batteries pri-
or to initial operation or when the battery change symbol
any rechargeable batteries!
Proceed as follows to insert or change the batteries:
- Disconnect all measuring leads from the meter and switch
it off.
- Fold out the mounting bracket (8) and unscrew the four
screws securing the battery compartment (9).
- Remove the cover of the battery compartment from the
meter. The batteries can be accessed now.
- Replace all the batteries with new ones of the same type.
Observe of the polarity markings in the battery compartment
when inserting the new batteries.
- Close and secure the battery compartment in reverse order.
The meter is ready for use once again.
Never operate the meter when it is open.
!RISK OF FATAL INJURY!
You must not use any rechargeable batteries!
Do not leave flat batteries in the device. Even batteries protected against leaking can corrode and
thus release chemicals which may be detrimental to your health or destroy the device.
Do not leave batteries lying around carelessly. They could be swallowed by children or pets. If
swallowed, consult a doctor immediately.
If the device is not used for longer periods of time, remove the batteries in order to
prevent leaking.
Leaking or damaged batteries may cause alkali burns if they come into contact with
the skin. It is therefore advisable to use suitable protective gloves.
Make sure that the batteries are not short-circuited. Do not throw batteries into the
fire.
Always replace all batteries at once. The use of new and discharged or old batteries
together affects the battery life. Always use batteries of the same type and from the
same manufacturer in a set of batteries. The batteries can be damaged by equalizing
currents and may leak.
Batteries must not be recharged or dismantled. There is danger of explosion.
34
appears on the display. You must not use