Inserting/Changing The Batteries - VOLTCRAFT VC-520 Bedienungsanleitung

Inserting/changing the batteries

The device is powered with two 1.5 V AAA batteries. You
needto insert a new, charged battery prior to initial operation or
when the battery change symbol
To insert/replace the battery, proceed as follows:
- Separate the connected measuring leads from the measur-
ing circuit and the measuring device. Switch off the meter.
- Loosen the two screws on the reverse side of the battery
cover and lift off the battery cover.
- Insert two new batteries in the battery compartment observ-
ing the correct polarity.
- Now, close the cover carefully again.
Never operate the measurement device when it is open. !RISK
OF FATAL INJURY!
Do not leave flat batteries in the device. Even batteries protect-
ed against leaking can corrode and thus release chemicals
which may be detrimental to your health or destroy the battery
compartment.
Do not leave batteries lying around carelessly. They might be
swallowed by children or pets. If swallowed, consult a doctor
immediately.
Remove the batteries if the device is not used for longer periods
of time to prevent leaking.
Leaking or damaged batteries may cause alkali burns if they
come in contact with the skin. Therefore, use suitable protective
gloves.
Make sure that the batteries are not short-circuited. Do not
throw batteries into fire!
Batteries may not be recharged. Danger of explosion.
appears on the display.
-
+
+
-
45