Inserting / Removing The Battery Pack Into / Out Of The Device; Checking The Battery Charge State; 2-Speed Gear Operation; Torque Preselection - Parkside PSBS 24 A1 Bedienungs- Und Sicherheitshinweise

Push the coupler (see Fig. A) onto the recharge-
able battery pack
into the socket.
The red charge indicator LED
charging process has started. The red light goes out
as soon as the battery pack
The green charge indicator LED
the charging process is complete and the
battery pack is ready for use.
9
NOTE: If the rechargeable battery pack is discharged
and still hot from from the tool being used, it will not
be recharged immediately. The charging process
will start automatically, as soon as the rechargeable
battery pack has cooled to an adequate temperature.
½
Do not use the quick-charge process to charge
a battery pack for a second time in close
9
succession. Otherwise there is the danger that
the battery pack
9
and its useful life and that of the charger reduced.
½
Switch the charger
utes between successive charging processes.
To do this pull the mains plug out of the socket.
©
Inserting / removing the battery
pack into / out of the device
Removing the rechargeable battery pack:
In order to remove the rechargeable battery,
turn the appliance 180°.
Press the unlocking button
chargeable battery pack
Inserting the rechargeable battery pack:
Push the rechargeable battery pack
the appliance.
© Checking the battery
charge state
Press the battery charge state test button
The remaining charge capacity is shown on the
LED display 2 .
9 . Insert the mains plug
indicates that the
15
is fully charged.
9
shows that
16
will become overcharged
off for at least 15 min-
14
and push the re-
8
out of the appliance.
9
9 onto
3
©

2-speed gear operation

In first gear (gear selector switch
position: 1)
the device achieves a speed of approx. 500 min
and a high torque. For example, for screwing work
with small screw diameters.
In second gear (gear selector switch
position: 2)
the device achieves a speed of approx. 1800 min
and a lower torque. For example, for rapid drill
progress in masonry or large drill or screw diameters.
©

Torque preselection

Use the torque preselection ring
When this set torque is reached the clutch decouples
the drive. This allows you to screw in screws to a
predetermined depth, which is ideal e.g. for screw-
ing in a series of screws.
Select a lower setting for small screws or soft
materials.
Select a high setting for large screws, hard ma-
terials, or when screwing out screws.
For drilling tasks select drilling setting by placing
the torque preselection ring in the
© Drilling / screwing /
impact drilling
Drilling / screwing:
Turn the setting ring
Impact drilling:
Turn the setting ring
©

Changing inserted tools

.
Your cordless hammer drill has a fully automatic spindle
lock and is fitted with a single-sleeve drill chuck
with radial lock "Made in Germany" by
Once the motor has come to a halt, the drive shaft
is automatically locked so that the quick-action drill
Preparing for use
1
in
1
to set the torque.
13
position.
12 to the symbol .
to the symbol .
12
GB/IE
-1
in
-1
.
11