Safety Guidelines For Battery Chargers; Before Use; Charging The Battery Pack (See Fig. A); Inserting/Removing The Battery Pack - Parkside PABS 20-Li F7 Originalbetriebsanleitung

Safety guidelines for battery
chargers
This appliance may be used by
■
children aged 8 years and above
and by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under su-
pervision or have been told how to
use the appliance safely and are
aware of the potential risks. Do not
allow children to use the appliance
as a plaything. Cleaning and user
maintenance tasks may not be car-
ried out by children unless they are
supervised.
To avoid potential risks, if the mains
■
cable of this appliance is damaged,
it must be replaced by the manufac-
turer, or its customer service depart-
ment or a similarly qualified person.
The charger is suitable
for indoor use only.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3.
♦ An up-to-date battery compatibility list can be
found at www.Lidl.de/Akku.
PABS 20-Li F7

Before use

Charging the battery pack (see fig. A)
CAUTION!
► Always disconnect the mains plug before
removing the battery pack 8 from or insert-
ing it into the charger.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level must be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C.
♦ Insert the battery pack 8 into the high-speed
charger e (see fig. A).
♦ Insert the power plug into the socket. The green
charge control LED t lights up briefly, then the
red charge control LED r lights up.
♦ The green control LED t indicates that charging
is complete and the battery pack 8 is ready for
use.
♦ Insert the battery pack 8 into the appliance
(see fig. B).

Inserting/removing the battery pack

Inserting the battery pack:
♦ Set the rotation direction switch 3 to the
middle position (lock, see fig. C). Slide the
battery pack 8 into the handle until it engages
(see fig. B).
Removing the battery pack:
♦ Press the release button 9 and remove the
battery pack 8 (see fig. D).
GB │ IE │ 7 ■