Initial Start-Up; Checking The Battery Charge Level; Inserting/Removing The Device's Battery Pack - Parkside PBHA 12 A1 Originalbetriebsanleitung

GB MT
7) ADDITIoNAL SAFETy
INSTrUCTIoNS
a) Hold the appliance by the insu-
lated gripping surfaces when
performing work in which the
tool may come into contact with
hidden wiring. Contact with a live
wire can also cause a charge in metal
parts of the appliance and result in an
electric shock.
b) Hold the device by the insulated
gripping surfaces when perform-
ing work in which the cutting
tool may come into contact with
hidden wiring or its own cord.
If the screw were to come into contact
with a live electrical cable, metal parts
of the appliance could also become live
and cause an electric shock.
8) rESIDUAL rISKS
Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this electric
tool may present the following hazards:
a) Cuts
b) Ear damage if working without ear
protection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
52
implants consult their doctor and the
manufacturer of their medical im-
plant before operating the machine.
Warning! observe the safety
information in the operating
instructions for your Parkside
X 12 v Team series recharge-
able battery.

Initial start-up

Place the rotational direction switch
into the central position before car-
rying out any work with the electri-
cal tool (e.g. maintenance, change
of tool etc.), as well as during
transportation and storage. There is
a risk of injury if the on-off switch is
accidentally activated.
Checking the battery charge
level
The battery's (
cated by the charge state indicator (
The LEDs indicate the battery's charge
level, when the device is in operation.
Press and hold the power button (
red-yellow-green => Battery fully charged
red and yellow => Battery half charged
red => Battery needs
Inserting/removing the
device's battery pack
Inserting the battery pack:
• Push the rotational direction switch
( 7) into the central position (lo-
cked). Allow the battery pack (
latch into the handgrip.
9) charge level is indi-
to be charged
6).
8).
9) to