FP FPi 2500 Betriebsanleitung Seite 71

Insert Problems
Symptom
Envelope leaves sys-
tem at the back.
Insert failure.
8
Envelope not always
ejected from sealer.
Address not readable
from window
66
Possible cause
Envelopes stacked
reversed in the hop-
per.
Envelope flap sticks.
Wrong envelope type
used (not according
to specifications).
Envelope throat incor-
rect.
Envelope glued in-
side.
Window not glued
properly.
Document set
skewed.
Document set to
wide.
Fingers did not open
the envelope.
Sealing area dirty.
Address position not
correctly defined.
Remedy
Place envelopes cor-
rectly in hopper.
Store envelopes ac-
cording to specifica-
tions.
Change envelopes
according to specific-
ations.
Check envelope spe-
cifications.
Eliminate faulty envel-
opes.
Eliminate faulty envel-
opes.
Adjust side guides.
-
Choose envelope
within specifications.
Clean sealing area.
Change address pos-
ition.
Reference
Loading envelopes
on page 16
Envelope specifica-
tions
Envelope specifica-
tions
Envelope specifica-
tions
-
-
Loading Documents
Envelope specifica-
tions
Envelope specifica-
tions
Maintenance sched-
ule on page 48
Address position on
page 27