Calibrate Sensors - FP FPi 2500 Betriebsanleitung

Calibrate Sensors

If you get an error on dusty photocells, first you have to clean the photocells on the document
path or the envelope path. After cleaning the photocells you have to calibrate the sensors.
1. Remove all paper and envelopes from the system.
2. From the Settings Menu select [Supervisor], select [Maintenance],
select [Photocells].
3. Select [Calibrate] to start the calibration of the photocells.
After a short time, a message is displayed that shows the result of the calibration.
This icon means there is still paper at the cell or the cell is broken
This icon means the cell is dusty and must be cleaned.
8
61