Removing/Inserting The Dust Bin; Operation - Cleanmaxx Z 08919 Gebrauchsanleitung

Removing/inserting the dust bin

Operation

CAUTION!
❐ Never hold the nozzles close to parts of your body during use and do not place your
hands inside the nozzles. They could become stuck to the device/injured. If the
vacuum cleaner becomes fi rmly attached due to suction, turn it off immediately (
press down the On / Off switch).
❐ Keep the nozzles away from animals during operation. Never attempt to vacuum
animals using the device. They could become stuck to the device/injured. If the
vacuum cleaner becomes fi rmly attached due to suction, turn it off immediately (
press down the On / Off switch).
❐ Switch on the vacuum cleaner only when you have checked that all parts have been
properly assembled and that the dust container and all fi lters have been inserted
correctly.
❐ To ensure that the cable does not become hot during operation, pull out at least two
thirds of its total length from the device before you switch on the vacuum cleaner. Do
not pull out the cable with force up to its maximum length (not further than the red
marking on the cable) in order to prevent damage!
❐ Always switch the device off fi rst and remove the mains plug from the mains socket
before replacing a nozzle or attaching or removing any accessories.
❐ On no account should the device be used to suck up the following:
– Liquids or wet substances (e.g. wet carpet shampoo)
– Glowing ash, cigarette ends, matches, etc.
– Infl ammable or explosive substances
– Very fi ne dust (e.g. concrete dust), ash or toner
– Pointed, hard objects such as large pieces of broken glass
1. Make sure that the accessories are attached correctly to the device (see the „As-
sembly" chapter).
2. Pull the mains cable out of the unit as far as you require, ideally up to the yellow
marking, but not further than the red marking on the cable!
3. Insert the mains plug into a properly installed mains socket that is easily accessible.
• Removal: Push the release button on the dust bin and
take it out of the device by the handle.
• Insertion: Take the dust bin by the handle and fi rst place
the bottom of the bin in the device (the bottom is facing
down and handle is facing up). Then push the hand-
le against the device housing until the dust bin audibly
locks into place. Hold the device by the handle and lift it to
check whether the dust bin is properly seated.
26