Inserting/Removing The Telescoping Tube; Adjusting The Length Of The Telescoping Tube; Mounting/Removing Suction Nozzles; Removing/Inserting The Dust Bin - Cleanmaxx Zyklon EV-805-S14 Gebrauchsanleitung

Inserting/removing the telescoping tube

Adjusting the length of the telescoping tube

Mounting/removing suction nozzles

• Insert the open end of the telescoping tube in one of the enclosed suction nozzles
up to the stop. Turn the nozzle back and forth slightly in the process.
• The suction nozzles can also be attached directly to the suction hose without the
telescoping tube for more fl exibility.
• To remove a suction nozzle pull it off.
• You can put the suction nozzles onto the holder supplied for convenient storage.
Clip the holder on the telescoping tube.

Removing/inserting the dust bin

09242_de-gb-fr-nl_V0.indb 23 09242_de-gb-fr-nl_V0.indb 23
• Insert the open end of the handle into the corresponding
opening on the telescoping tube. In the process, turn the
handle back and forth somewhat. Check to make sure
that the connection is secure.
• To remove the telescoping tube pull it off of the handle.
• Push the slider on the telescoping tube down and set the
desired length.
• Release the slider and move the tube forward until it locks
into place.
• Removal: Push the release button on the dust bin and
take it out of the device by the handle.
• Insertion: Take the dust bin by the handle and fi rst place
the bottom of the bin in the device (the bottom is fac-
ing down and handle is facing up). Then push the han-
dle against the device housing until the dust bin audibly
locks into place. Hold the device by the handle and lift it to
check whether the dust bin is properly seated.
23
06.06.2014 12:33:18 06.06.2014 12:33:18