Mounting/Removing Suction Nozzles; Removing/Inserting The Dust Bin; Operation - Cleanmaxx Z 08938 Gebrauchsanleitung

Mounting/removing suction nozzles

• Insert the open end of the telescoping tube in one of the enclosed suction nozzles
up to the stop. Turn the nozzle back and forth slightly in the process.
• The suction nozzles can also be attached directly to the suction hose without the
telescoping tube for more fl exibility.
• To remove a suction nozzle pull it off.

Removing/inserting the dust bin

Operation

ATTENTION!
❐ During use, always keep the nozzles away from body parts and animals and do not
reach into them. You could be caught or injured. If something does get caught in the
vacuum cleaner, turn it off immediately (depress the On/Off switch
❐ Only turn on the vacuum cleaner once you are sure that all parts have been
completely mounted and that the dust bin, dust fi lter and the exhaust fi lter have
been properly inserted.
❐ To prevent the cord from becoming too hot when in use, pull at least two thirds of
its entire length out of the device before you switch on the vacuum cleaner. Do not
forcefully pull out the cord up to the stop point (no further than up to the red mark on
the cord) in order to prevent damage!
❐ Always turn off the device fi rst and pull the mains plug out of the socket before you
change a nozzle or attach or remove other accessories!
❐ Do not in any case vacuum up the following:
– Liquids or wet materials (such as wet carpet shampoo)
– smouldering ashes, cigarette butts, matches etc.
– fl ammable or ignitable materials
– very fi ne dust (e.g. cement dust), ash or toner
– hard, pointy objects such as bigger glass shards
1. Make sure that the respective accessory is properly mounted on the device (see
chapter "Assembly").
• Removal: Push the release button on the dust bin and
take it out of the device by the handle.
• Insertion: Take the dust bin by the handle and fi rst place
the bottom of the bin in the device (the bottom is facing
down and handle is facing up). Then push the hand-
le against the device housing until the dust bin audibly
locks into place. Hold the device by the handle and lift it to
check whether the dust bin is properly seated.
25
).