Removing/Inserting The Dust Bin; Operation - Cleanmaxx Z 07338 Gebrauchsanleitung

• To remove a suction nozzle pull it off.
Information regarding the animal hair fl oor nozzle:
When the animal hair fl oor nozzle is removed it can happen that the
adapter sleeve remains in place on the telescopic tube. Please note that
the other suction nozzles can only be applied to the telescopic tube
when the adapter sleeve has been removed from the tube!

Removing/inserting the dust bin

Operation

ATTENTION!
■ During use, always keep the nozzles away from body parts and animals and do not
reach into them. You could be caught or injured. If something does get caught in the
vacuum cleaner, turn it off immediately (depress the On/Off switch
■ Only turn on the vacuum cleaner once you are sure that all parts have been comple-
tely mounted and that the dust bin and the fi lter have been properly inserted.
■ To prevent the cord from becoming too hot when in use, pull at least two thirds of
its entire length out of the device before you switch on the vacuum cleaner. Do not
forcefully pull out the cord up to the stop point (no further than up to the red mark on
the cord) in order to prevent damage!
■ Always turn off the device fi rst and pull the mains plug out of the socket before you
change a nozzle!
■ Do not in any case vacuum up the following:
– Liquids or wet materials (such as wet carpet shampoo)
– smouldering ashes, cigarette butts, matches etc.
– fl ammable or ignitable materials
– very fi ne dust (e.g. cement dust), ash or toner
– hard, pointy objects such as bigger glass shards
1. Make sure that the respective accessory is properly mounted on the device (see
chapter "Assembly").
2. Pull the mains cord only as far out of the housing as you need, ideally up to the yel-
low mark, but no further than up to the red mark on the cord!
3. Insert the mains plug in a properly installed socket that is easily accessible.
4. Press the On/Off switch
23
• Removal: Push the release button on the dust bin and
take it out of the device by the handle.
• Insertion: Take the dust bin by the handle and fi rst place
the bottom of the bin in the device (the bottom is facing
down and handle is facing up). Then push the hand-
le against the device housing until the dust bin audibly
locks into place. Hold the device by the handle and lift it to
check whether the dust bin is properly seated.
to turn the vacuum cleaner on.
EN
).