Charging The Battery; Initial Operation; Switching On And Off; Checking The Charge Status Of The Rechargeable Battery - Parkside PSSA 3.6 C3 Betriebsanleitung

Ensure that the equipment is
charged for no longer than 3 hours
without interruption. The battery
and equipment could be damaged
and they consume energy unneces-
sarily in case of longer charging
time. Overcharging invalidates the
guarantee.
• The device may only be powered with
SELV (Safety Extra Low Voltage) as
marked on the device.
• Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short pe-
riods in succession.
• Use the charger supplied to charge
the Li-ion battery installed in the equip-
ment.
• Recharge the battery if the equipment
runs too slowly.
• In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmen-
tal protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.

Charging the battery

1. Connect the charging cable con-
nector (12) with the charging
socket (7) of the device.
2. Plug the charger (
electrical outlet.
3. The battery indicator (3) lights
up:
Red LED lights up:
Battery charging.
Green LED lights up:
Battery is charged.
4. After the charging process,
disconnect the charger (
from the mains supply.

Initial Operation

Switching ON and OFF

Overload protection: The safety cut-off of the
device switches off in case of overload. Re-
lease the On/Off switch, the device can be
switched on again after a few seconds.
Checking the charge status of
the rechargeable battery
The battery indicator (
state of charge of the battery.
•

Set the direction of rotation

You can select the direction of rotation with
13) into an the direction switch (clockwise and anti-
clockwise direction) and secure the device
against accidental start up.
13)
1. Press the on/off switch (8) to start
the device. The LED work light
(10) lights up during operation.
2. To turn it off, release the on/off
switch (8).
Press the On/Off switch, the state of
charge of the battery is displayed by
turning on the 3 coloured LED lights:
Green LED lights up brightly: Battery is
fully charged.
Red and yellow LEDs light up brightly:
Battery has a residual charge (< 90 %).
Red LED lights up brightly: Battery is
empty, please charge.
1. Wait for the device to shut-down.
2. Clockwise direction:
Press direction switch (9) to
the right.
3. Anticlockwise direction:
Press direction switch (9) to
the left.
GB IE CY
3) signalises the
11