Additional Safety Instructions; Charging The Battery; Recharging The Battery - Parkside RAPIDFIRE 2.1 Originalbetriebsanleitung

GB MT
on a combustible surface
(e.g. paper, textiles). Risk of
fire due to heating during charg-
ing.
• If the power cable for this equip-
ment is damaged, it must be re-
placed by the manufacturer, a cus-
tomer service agent of the same
or a similarly qualified person in
order to prevent hazards.

Additional safety instructions

- Suitable for indoor use only.
- Do not attempt to charge non-
rechargeable batteries.
- The housing must under no
circumstances be opened. The
mains unit must not continue to
be used if the housing is dama-
ged.
- Lithium-ion batteries should only
be charged within the ambient
temperature range stipulated in
the instruction manual. Charging
at very low temperatures (e.g.
under 0˚C) or very high tempe-
ratures (e.g. above 45˚C) can
lead to major safety issues with
the battery.
- Do not mount the charger to the
wall.

Charging the battery

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
60
Charge the battery in a dry room
only.
There is a risk of injury due to elec-
tric shock.
Only use the original charger from
the package to charge the battery.
• The device may only be powered
with SELV (Safety Extra Low Volt-
age) as marked on the device.
• Charge the battery before the first
time of use.
• Always take heed of the applicable
safety instructions as well as the en-
vironmental protection regulations
and information.
• The warranty excludes all defects
caused by improper handling.

Recharging the battery

1. Connect the USB charging cable
( 11.2) to the charging socket (
11.3) of the mains plug..
2. Connect the charger plug to the
charging socket (
vice.
3. Plug the battery charger (
into a mains outlet.
4. When the battery is fully re-
charged unplug the battery
charger (
The charge state indicator (
3 LEDs are on (red, yellow, green):
Battery charged
2 LEDs are on (red, yellow):
Battery partially charged
1 LED is on (red):
Battery needs to be charged
6) of the de-
11)
11) from the mains.
5) lights up.