Charging The Battery; Inserting/Removing The Battery; Recharging The Battery - Parkside PBSA 12 B1 Originalbetriebsanleitung

• Do not operate the charg-
er on a combustible sur-
face (e.g. paper, textiles).
Risk of fire due to heating dur-
ing charging.
• If the connection cable
of this appliance is dam-
aged, it must be replaced
by the manufacturer or
their customer service or
by a similarly qualified
person in order to avoid
hazards.
• The battery of the appliance is
not fully charged at the time of
delivery. It therefore needs to be
fully recharged before you use it
for the first time. Slot the battery
into the base and plug the bat-
tery charger into a mains outlet.
• Do not use the charger to charge
non-rechargeable batteries.

Charging the battery

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only.
Prior to attaching the charger,
check that the battery's outer
surface is clean and dry.
There is a risk of injury due
to electric shock.
Only use the original charger from
the package to charge the battery.
• Charge the battery before the first time
of use. Do not briefly charge the bat-
tery several time in a row.
• Recharge the battery when you notice
that the appliance is becoming slower.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Inserting/removing the
battery
1. To insert the battery (7), place
it on the guide track and push it
back into the appliance. It will
audibly snap in.
2. To remove the battery (7) from
the appliance, press the release
buttons (8) on the battery and
pull out the battery.

Recharging the battery

1. Remove the battery (7) from the
appliance i necessary.
2. Insert the battery (7) in the charg-
ing compartment of the battery
charger (13).
3. Plug the battery charger (13) into
a mains outlet.
4. When the battery is fully re-
charged unplug the battery
charger (13) from the mains.
5. Pull the battery (7)out of the bat-
tery charger (13).
GB MT
41