GB
MT
Charge the battery only in
dry areas.
There is a risk of injury from
electric shock.
•
The device may only be powered with
SELV (Safety Extra Low Voltage) as
marked on the device.
•
Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short pe-
riods in succession.
•
To charge the integrated Li-ion battery
of the device, preferably use the
battery charger supplied.
•
In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmen-
tal protection.
•
Defects resulting from improper han-
dling are not subject to the guarantee.
Charging the battery
1. Connect the charging cable con-
nector (12) with the charging
socket (7) of the device.
2. Plug the charger (
electrical outlet.
3. The battery indicator (3) lights up:
red => Start of charging
red and yellow =>
Battery appr. half charged
red-yellow-green =>
Battery fully charged.
4. After the charging process,
disconnect the charger (
from the mains supply.
Initial Operation
Wearing hearing protection reduc-
es the risk of hearing damage.
50
Switching ON and OFF
Overload protection: The safety cut-off of
the device switches off in case of overload.
Release the On/Off switch, the device can
be switched on again after a few seconds.
Checking the charge status
of the rechargeable battery
The battery indicator (
state of charge of the battery.
•
Set the direction of rotation
13) into an
You can select the direction of rotation with
the direction switch (clockwise and anti-
clockwise direction) and secure the device
against accidental start up.
13)
1. Press the on/off switch (8) to start
the device. The LED work light
(10) lights up during operation.
2. To turn it off, release the on/off
switch (8).
Press the On/Off switch, the state of
charge of the battery is displayed by
turning on the 3 coloured LED lights:
red-yellow-green => Battery fully
charged
red and yellow =>
Battery appr. half charged
red => Battery is empty, please charge.
1. Wait for the device to shut-
down.
2. Clockwise direction:
Press direction switch (9) to
the right.
3. Anticlockwise direction:
Press direction switch (9) to
the left.
4. Switch lock: Bring direction
switch to neutral position.
3) signalises the