Adjusting The Length Of The Telescoping Tube; Mounting/Removing Suction Nozzles; Removing/Inserting The Dust Container; Operation - Cleanmaxx Z 08925 Gebrauchsanleitung

Adjusting the length of the telescoping tube

Mounting/removing suction nozzles

• Insert the open end of the telescoping tube in one of the enclosed suction nozzles
up to the stop. Turn the nozzle back and forth slightly in the process.
• The suction nozzles can also be attached directly to the suction hose without the
telescoping tube for more fl exibility.
• To remove a suction nozzle pull it off.

Removing/inserting the dust container

Operation

CAUTION!
❐ Never hold the nozzles close to parts of your body during use and do not place your
hands inside the nozzles. They could become stuck to the device/injured. If the
vacuum cleaner becomes fi rmly attached due to suction, turn it off immediately (
press down the On / Off switch).
08925_DE-GB-FR-NL_V0.indb 25 08925_DE-GB-FR-NL_V0.indb 25
• Push the slider on the telescopic tube downwards and
then pull the telescopic tube out to the required length.
• Release the slider and move the tube slightly up or down
until it engages.
• Removal: Push the release button on the dust container
and take it out of the device by the handle.
• Insertion: Take the dust container by the handle and fi rst
place the bottom of the container in the device (the bottom
is facing down and handle is facing up). Then push the
handle against the device housing until the dust container
audibly locks into place. Hold the device by the handle
and lift it to check whether the dust bin is properly seated.
25
26.05.2014 09:20:35 26.05.2014 09:20:35