Inhaltsverzeichnis
Werbung
PILOT SCREW ADJUSTMENT
10. Install:
11. Inspect:
12. Check:
Checking steps:
Slightly loosen the oil gallery bolt 1.
G
Start the engine and keep it idling until oil
G
starts to seep from the oil gallery bolt. If no
oil comes out after one minute, turn the
engine off so it will not seize.
Check oil passages, oil filter and oil pump
G
for damage or leakage.
Start the engine after solving the prob-
G
lem(s) and recheck the oil pressure.
Tighten the oil gallery bolt to specification.
G
PILOT SCREW ADJUSTMENT
1. Adjust:
Adjusting steps:
NOTE:
To optimize the fuel flow at a smaller throttle
opening, each machine's pilot screw has
been individually set at the factory. Before
adjusting the pilot screw, turn it in fully and
count the number of turns. Record this num-
ber as the factory-set number of turns out.
Turn in the pilot screw until it is lightly
G
seated.
Turn out the pilot screw by the factory-set
G
number of turns.
3 - 17
Oil filler plug
G
Engine (for oil leaks)
G
Oil level
G
Refer to "ENGINE OIL LEVEL INSPEC-
TION".
Oil pressure
G
Oil gallery bolt:
10 Nm (1.0 m • kg, 7.2 ft • lb)
Pilot screw 1
G
Pilot screw:
2 turns out (example)
INSP
ADJ
Werbung
Inhaltsverzeichnis
