Operating Procedure; Connections To Receiver - Carson Reflex Stick Ultimate Touch Betriebsanleitung

Caution
GB
Control of models is impossible with insufficient or
no voltage in the transmitter or receiver. A receiver
battery, that is too weak will move the servo(s) very
slowly, and that may cause erratic operation of your
model. When using a car that operates both the
electric motor and receiver on the same battery,

Operating Procedure

Many publications say that the setup sequence
for the transmitter and receiver don't play a role
anymore with 2,4 GHz sets. However, we recommend
sticking to the sequence typical for previous sets.
• Before operation: First turn on the transmitter,
then the receiver. Lastly, connect the drive battery
to the control unit.

Connections to Receiver

BEC-Receiver
Battery eliminator is installed in the receiver circuitry.
The receiver gets supplied with current through the
drive battery that runs the engine. NiMH battery
from 6 V to 8.4 V can be used for the receiver.
Motorplugs
Receiver
Do not connect a separate power supply to the
receiver!
80 CARSON Reflex Stick Ultimate Touch 500501002
such as a BEC system, you should discontinue
operating the car, when the top speed becomes
sharply reduced, otherwise loss of control will result
soon afterwards.
• After operation: Disconnect the battery from
the control unit. Turn the receiver off, and then the
transmitter.
• Before and after operating the transmitter, make
sure that trim is in the desired place and that all
checks have been made.
Batteries of higher voltage may damage the receiver
and servos.
Use only a speed controller which has the exclusive
connector for the BEC system.
Batteryplug
+
40A
Electronic
Speed Controller
BRUSHLESS MOTORS
-
EESCB140A003
CH2
CH1
ATTENTION
Make sure that male and female connectors
have the correct polarity!
Servo