Carson Reflex Stick Ultimate Touch Betriebsanleitung Seite 85

Telemetry module FS-SVT01
Battery voltage recognition module (Not included)
Procedure:
1. Connect one end of the 3-pin connecting cable
to the "Out" terminal of the telemetry module and
the other end to the "IN" terminal of the receiver,
or to the "IN" terminal of one of the sensors already
connected.
2. Switch on the transmitter and the model (receiver).
"Ext.voltage4: 12.40V" will now be displayed on
the main screen, which means that the installation
was successful.
Warning!!!
The polarity of the red and black connectors must never be reversed. Doing so would damage the
electronic components.
Advice
The sensor modules must always be connected to the "IN" terminal. Do not connect the sensors to the "OUT"
terminal, as otherwise incorrect values are transmitted to the receiver and the receiver and the telemetry
modules can be damaged.
CARSON Reflex Stick Ultimate Touch 500501002
x
+
3. Next, connect the red and black contact connector
to the balancer terminal of your LiPo driving
battery. The red connector is for the positive
terminal and the black for the negative terminal
(outermost black cable on the balancer connector,
see diagram).
Example: "Ext.voltage4: 12.4V" is displayed on the
transmitter screen. This is the current voltage value
of your LiPo battery which is connected to the
sensor module.
GB
85