Trims; Scaling Exponentials - Carson Reflex Stick Ultimate Touch Betriebsanleitung

1.15 Trims

GB
This function is to amend channels' output and value of channels' output.
So far there are a lot of player's uses it to amend center gravity of model
and Revomix caused by aerodynamic, etc. So it makes model more stable
in the air. This function is only available for CH1-CH4
The trims function individually adjusts the center position of each servo
of the 4 channels. It also can reset and display in real time the conditions
of 4 sticks and trim button.
The current condition of the trim will be displayed after touching the
Trims icon. Touch the reset button and all the trim value will be back to
0. The trims condition will be displayed when moving the trim stick in
any condition and it will be back to the original interface after 2 seconds.
As shown in the picture 21.4, the throttle is selected and move the trim
sticks to the position of +20.

1.16 Scaling Exponentials

This function is a special function which has two sub-functions: one is
dual rate setup and the other is exponent setup. Dual rate function is used
to set different rate according to different type of aircraft. For example:
Aircraft needs larger movement when you choose 3D and it needs
smaller movement when choose 3A. In addition, smaller movement
is appropriate for beginners and larger movement is appropriate
for practiced ones. All above needs to be completed by setting rate.
Exponential function is used to get a better effect for professionals.
When exp is positive, the sensitivity of neutral point data's output will be
decreased and the sensitivity of two terminal points will be increased. It is
opposite when Exp is negative.
Exponentials function is used to adjust the rate and exponential of the
airplane. Once activated, 2 buttons select which parameter value to
modify. The function can be set in 5 conditions. (Condition instruction
can be acquired on manual from page 104).
Rate: adjust the slope of the curve. The smaller is the slope, the shorter is
the throw of the corresponding servo.
Exp: adjust the linearity curve of all sticks or knobs (Ail, Ele , Thro., Rud,
VrA~VrE). Avalue of O corresponds to a perfectly linear curve. A positive
value decreases the sensitivity near the neutral position and increases it
on the extreme sides. A negative value increase the sensitivity near the
neutral position and decreases it on the extreme sides.
The vertical dotted line displays in real time the position of the corve. The
horizontal dotted line displays in real time the corve position after the
exponential function.
Select the stick or the Knob which need to set. After that, touch the
enable button to enable this function and then select the Rate button or
the Exp. button. Use the wheel to modify the corresponding value.
96 CARSON Reflex Stick Ultimate Touch 500501002
Pic. 21.4
Pic. 21.5