Rx Setup - Carson Reflex Stick Ultimate Touch Betriebsanleitung

1.38 RX setup

Set up the receiver. This function is used to set the
corresponding parameter of the receiver and the
sensors connected. RX setup menu.
(As shown in picture 21 .46)
Bind with a receiver: The transmitter enters in bind
mode. Once the receiver is correctly bound, press
the back button to return to normal operation. (As
shown in picture 21 .48)
AFHDS2: the default is a two-way communication
system. Touch the check box to toggle the two-way
communication telemetry RX battery monitor: Mo-
nitors the receiver battery voltage.
External sensor: Do not monitor the receiver po-
wer supply voltage but use an external sensor ins-
tead. This is useful when the receiver is powered by
an ESC. Connect the external sensor directly to the
main battery. (As shown in the picture 21 .47)
Low voltage: set the minimum voltage when the
battery is almost empty. default low voltage value
is 4.00V.
Alarm voltage: set the voltage under which an au-
dible alarm rings and the receiver battery icon in the
top tray blinks. (As shown in the picture 21 .49)
High voltage: set the maximum voltage when the
battery is full.
Default high voltage value is 5.00V.
CARSON Reflex Stick Ultimate Touch 500501002
Pic. 21.46 Pic. 21.47
Pic. 21.48 Pic. 21.49
GB
111