Cannel O Set; Functions Delay - Carson Reflex Stick Ultimate Touch Betriebsanleitung

1.23 Channel offset
This function is to revise model when there are some
deviations in structures.
Set channel offset rate from -50% to 50% based on
the channel neutral position. The default is 0%. This
function can be set in five conditions.
Select the desired point to set and move the wheel
to modify the corresponding value after activating
this function. The position of the corresponding
channel is displayed in real time.
The offset value of CH2 is adjusted to 10%, Move
the stick to the far left and the channel is displayed
as shown in picture 21.15, Move the stick to the
far right and the channel is displayed as shown in
picture 21.16.

1.24 Functions delay

This function is used to imitate some movements
of real aircraft, like flap movement and some other
special movements. For example, when the user is
flying 3D, he could do some smoothing to change
from NOR to 3D. Functions delay is used to slow
down the response speed of basic function. lt can
be adjusted from 0 seconds to 10 seconds and the
default is 0 seconds. Select the desired basic channel
and move the wheel to modify the delay time. The
position of the corresponding basic channel is
displayed in real time. The red bar represents stick
position and the green bar represents channel
position after setting.
As shown in picture 21.18 The delay time is set to 5
seconds. At this time, there will be a 5s delay when
moving aileron stick from bottom side to top side.
CARSON Reflex Stick Ultimate Touch 500501002
Ch2 stick to the far left Ch2 stick to the far right
Pic. 21.15
Pic. 21.17
GB
Pic. 21.16
Pic. 21.18
101