Throttle Needle; Butterfly Funktion - Carson Reflex Stick Ultimate Touch Betriebsanleitung

2.5 Throttle needle

GB
If the airplane structure has both an engine and a needle, set the throttle
needle according tothe features of engine power output. After that, the
needle position effected by throttle stick will be presented with curve
distribution, which can achieve a best flight effect. The 11 points (L, 2-10,
H) of throttle curve can be adjusted from 0% to 100%. The horizontal
dotted line displays in real time the throttle stick position, and the vertical
dotted line displays in real time the position. If the structure does not
have an engine or engine does not have a needle, then this function is
not available, and no icon will be displayed. This function can be set in 5
conditions respectively.
Select the desired point and move the wheel to modify the corresponding
value.
As shown in picture 22.06: Activate the throttle needle function by
touching the open button. Setting the value as shown in picture 22.6.
Point 2 is set to 20.0%,point 3 to 36.5%,point 4 to 51.5%, point 5 to 64.0%,
point 6 to 74.1 %,point 7 to 80.0%, point 8 to 85.5% ,point 9 to 90.0% and
point 10 to 95.0%.
ln this situation, when the position of the throttle is below the neutral,
that is (L,2~5), the acceleration of the throttle needle output is faster than
its position above the neutral (that is 6-10, H point).
2.6 Butterfly function
If the airplane structure has 1 aileron, 1 flap, 1 spoiler
and 1 elevator, it can be used to adjust the rate of
the corresponding motion (the default rate is +30%).
This function allows powerful brake operation by
simultaneously raising the left and right ailerons
and lowering the flaps (camber flap, brake flap). It
can be controlled by a switch or stick to achieve the
best flight effect. If the airplane structure does not
have any one of the aileron, flap, spoiler or elevator,
then there is no this function, and no icon will be
displayed. This function can be set in 5 conditions
respectively.
Select the function and then adjust the relative
parameter by touching the corresponding icon.
Adjust the corresponding value by moving the
wheel. Select a switch(SWA--SWH. LSW) by touching
it to enable or disable this function or select a stick
or knob (Ail. Ele . Thro. Rud, VRA~VRE) to control the
value.
For this example, adjust the aileron, aileron2, flap,
spoiler and elevator to 20% and select the knob to
control the value.
To the servo display function and then CH1 (aileron)
and CH6 (aileron2) are displayed as picture 22.8 to
limit the speed.
122 CARSON Reflex Stick Ultimate Touch 500501002
Pic. 22.06
Pic. 22.07
Pic. 22.08 Pic. 22.09