Servo Endpoints; Servo Reverse; Subtrim - Carson Reflex Stick Ultimate Touch Betriebsanleitung

1.12 Servo Endpoints

The end points function individually adjusts the low and high travel limit
of each servo on the 10 channels. Set the end points according to your
model mechanics.
• To choose the side of the channel 1 end point to set (steering), move
the steering wheel to the desired low or high side. The selected side will
be highlighted in yellow.
• The red needle represents the selected side. Use the wheel to move
it and modify the end point value. The position of the corresponding
channel is displayed in real time.

1.13 Servo Reverse

The reverse function individually reverses the direction of operation of
the servos on the 10 channels.
This dialog box contains 10 big check boxes, one for each channel. To
toggle the reverse state of a channel, just touch It.
In this example, only the third channel is reversed, the other channels
operate normally.

1.14 Subtrim

The sub trims function individually adjusts the center position of each
servo of the 10 channels. This is particularly useful when the servo
mechanics doesn't allow an adjustment fine enough. Touch the channel
which sub trim must me adjusted.
Use the wheel to move the red needle and modify the sub trim value
of the selected channel. The position of the corresponding channel is
displayed in real time.
In this example, the channel 1 has been selected and the red needle is
on 50 percent.
The sub trim of each channel can be assigned to a trim switch.
CARSON Reflex Stick Ultimate Touch 500501002
GB
95