Tail - Carson Reflex Stick Ultimate Touch Betriebsanleitung

2.9 V tail
GB
This function is used to control elevator and rudder
of models with V-tails. CH2 is a left V-tail by default
and CH4 is right V-tail _ When both V-tails move in
the same direction ,they act as elevators and when
both V-tails move in the opposite direction. This
function lets users adjust for left and right rudder
angle changes at elevator and rudder operation
of a V-tail airplane. V-tail is when 2 servos are used
together to control rudder movement as Elevators.
ln addition to each rudder side moving up and down
together, each side moves in opposite directions
when moving as Elevators. lt is better that the sum of
the rudder proportion and elevator proportion is no
more than 100%. The defaults are 50%. The position
of the corresponding channel displays in real time
while moving the stick.
Pic. 22.12
Select the elevator rate or rudder rate to set and
move the wheel to adjust the corresponding value.
For example: The airplane structure with V-tail.
Elevator is adjust to 60%
Ruder is adjudst to 40%
Pic 22.12 The rudder stick to the far left
Pic 22.13 The elevator stick to the topside
Pic. 22.13
124 CARSON Reflex Stick Ultimate Touch 500501002