Updating Firmware; Resetting Router To Factory Settings - Ceag CG-S / IP-Router + 1P Betriebsanleitung

Figure: Saving/uploading configuration

6.3 Updating firmware

CEAG makes updates for the firmware of the router available in the form of special .GUF files . These are available
from the website www.ceag.de.
To install a new firmware onto the device, go onto the SETTINGS tab in the web interface and then on the left under
CATEGORIES onto Firmware. The current firmware version is displayed.
Click on Search... next to
Uploading and subsequent updating of the firmware is initiated with the Upload button. The status LED changes to
red during installation of the new firmware. After the process is complete the router must be restarted so make the
modifications effective.
Figure: Updating firmware

6.4 Resetting router to factory settings

Implement the following process to reset the CG-S / IP Router+ 1P to its factory settings:
1. Disconnect the power supply plug and wait half a minute.
2. Reconnect the power supply and immediately press the Factory Reset button (see figure, ) on the top of the
housing until the Start/Reset LED begins to flash (duration approx. 10 seconds).
3. Release the Factory Reset button and press it again for one second. The LED flashes quicker, and then quicker
again. Then it lights up continuously. The resetting process has started.
4. After around one minute the LED Start/Reset extinguishes for the first time, followed by a short flash. It then
lights up continuously for approx. one minute. When it goes off for a second time the device is restarted and
resetting to factory settings is complete.
The router settings have now been reset to factory specifications.
With resetting to factory settings the IP address is modified back to 192.168.1.250. Chapter 3.3
„Verbindung zum Web-Interface herstellen" informs about how to connect to the device. Any users created
are also deleted and the „admin" default user is created again.
50
„Gesytec Update File" to upload (*.guf) and select the required file on your local memory.