Strobe Flash Mode - Metz MECABLITZ 58 AF-2 Canon Bedienungsanleitung

Some cameras only support the
camera is set to the manual operating mode M.

5.7 Strobe flash mode

The strobe flash mode is a manual flash mode. It allows several flash expo-
sures to be made on a single photo, which can be especially interesting for
movement studies or special effect images. In strobe flash mode, several flashes
at a certain flash frequency are emitted. For this reason, this function is only pos-
sible with a partial light output of 1/4 or less.
The flash frequency (flashes per second) for a stroboscope image can be set bet-
ween 1 ... 50 Hz in 1 Hz intervals, and the number of flashes can be set bet-
ween 2 ... 50 in intervals of one.
Setting procedure:
• Press the
M HSS
Mode
LC display.
• Choose the flash mode
Set
keys. The flash mode
setting takes effect immediately.
• Press the button
N15:f10
the normal view. If the button
Hz
MZoom 24
display will change back to the normal view after
3.6 m P1/32
about 5 seconds.
Mode Para Sel
M
manual flash mode when the
button until „Mode" flashes on the
Mode
using the and
is then highlighted. The
to change the LC display back to
is not pressed, the
Strobe number of flashes (N)
In strobe mode, the number of flashes per shot (N) can be selected.
The number of flashes can be set from 2 to 50 in intervals of one. The maximum
manual partial light output is automatically adjusted to this number.
Strobe flash frequency (f)
Strobe mode allows you to select the flash frequency (f), which indicates the num-
ber of flashes per second. The number of flashes can be set from 1 to 50 in inter-
vals of one. The maximum manual partial light output is automatically adjusted
to this number.
Setting procedure:
• Press the button (Parameters) until the desired
Para
flash parameter (N or f) flashes on the LC display.
+
• Set the desired value using the
The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
The maximum possible partial light output depends on the ISO and aperture set-
tings, and is automatically set in strobe mode. If you desire short flashes, you can
manually reduce the partial light output to the lowest value of 1/256.
The mecablitz LC display will indicate the flash-to-subject distance required for a
correct flash exposure, given the parameters selected. By changing the aperture
setting or the partial light output, this value can be adjusted to fit the actual
distance to the subject.
2.1 m
–
/ buttons.
Para
is not pressed, the
N24
+
–
121