Aperture (F) - Metz MECABLITZ 58 AF-2 Canon Bedienungsanleitung

TTL/E-TTL/A/E-TTL-HSS M/M HSS
— — N
— —
— P
F F
Zoom Zoom Zoom
EV — —
ISO ISO ISO
• Set the desired value using the
immediately.
• Press the button to change the LC display back to the normal view. If the
button is not pressed, the display will change back to the normal view
after about 5 seconds.
Number of strobe flashe
f Strobe flash frequency
P Manual partial light output
F Aperture
Mainreflektor position
Manual flash exposure correction
Light sensitivity
+
–
/ buttons. The setting takes effect

6.2 Aperture (F)

Table 1
If there is no digital data transfer between the camera and flash unit, the apertu-
re can be set by hand from 1.0 to 45 (at ISO 100), in intervals of one full aper-
ture. For flash modes A (automatic) and M (manual), the camera and flash unit
have to be set to the same aperture.
Setting procedure:
• Press the button (Parameters) until „F" flashes
Para
on the LC display.
• Set the desired value using the
The setting takes effect immediately.
• Press the button
to the normal view. If the button
the display will change back to the normal view after
about 5 seconds.
During digital data transfer between the camera and flash unit, interme-
diate values are also adjusted. During TTL-/E-TTL-flash mode, setting the
aperture on the flash unit is only necessary to achieve the correct distance
range indication, not for the function of the flash.
+
–
/ buttons.
to change the LC display back
is not pressed,
F 4.0
A
AZoom 70
7,7 m ISO 200
Mode Para Sel
A F 8.0
AZoom 70
3,8 m ISO 200
+
Para –
123