Special Functions (Select Menu); Setting Procedure For The Special Functions; Beep Function - Metz MECABLITZ 58 AF-2 Canon Bedienungsanleitung

7 Special functions (Select menu)

Special functions are selected using the
model and flash mode set, various special functions are available. If certain spe-
cial functions are not supported by your camera, these functions may not be
displayed in the menu. Also see table 2 for more information.

7.1 Setting procedure for the special functions

When a button is pressed for the first time, the LC
display is illuminated.
Select
• Press the
Beep on the display.
Mode Para Sel
• Use the
choice or special function from the menu. The selected
menu item will be highlighted against a dark
background.
TTL/E-TTL/A/E-TTL-HSS
The following special
functions are available,
REAR
depending on the mode
Beep
and camera model:
Remote
Standby
KEYLOCK
ZoomExt
ZoomSize
m / ft
Table 2
AF-BEAM
126
button. Depending on the camera
Sel
key repeatedly until „Select" appears
Sel
and keys to select the item of your
M/M HSS
–
–
REAR
Beep Beep
Remote Remote
– –
FB
Standby Standby
ML ML ML
KEYLOCK KEYLOCK
ZoomExt ZoomExt
ZoomSize ZoomSize
m / ft m / ft
AF-BEAM AF-BEAM
• Press the key to confirm the special function
Set
selection.
• Choose the setting desired using the
keys. The setting takes effect immediately.
• Press repeatedly to return the display to its nor-
mal reading. If the button is not pressed, the
display will change back to the normal view after
about 5 seconds.
7.2 Beep function (Beep)
The beep function allows the user to receive an acoustic signal for certain func-
tions of the flash unit. This allows the photographer to concentrate fully on the
subject and taking the picture, and not have to worry about any optical status
indicators.
The beep function signals when the flash is ready, when the correct flash exposu-
re has been reached, or when an error occurs.
Acoustic signals after the flash unit has been turned on:
• A short (about two seconds) uninterrupted beep signal after turning the flash
on indicates that the flash unit is ready.
Beep signals after taking a photograph:
• A short (about two seconds) uninterrupted beep signal directly after a picture is
taken indicates that the shot was exposed correctly and the flash is ready
again. If no beep signal sounds, then the shot was underexposed.
• A broken (— — —) beep signal directly after a shot indicates that the shot
was correctly exposed. The flash is only ready however after a second (about
two seconds) continuous beep.
Beep signals when adjusting automatic mode settings:
• A short beep signal as an alarm in automatic mode indicates that the aperture
and ISO settings exceed the permissible light control range. The auto aperture
of the mecablitz is then automatically adjusted to the next permissible value.
1/1
and
Set