Strobe Flash Mode - Metz Mecablitz 64 AF-1 digital -Sony Bedienungsanleitung

7.6 Strobe flash mode

The strobe flash mode is a manual flash
mode. It allows several flash exposures to be
made on a single photo, which can be espe-
cially interesting for movement studies or
special effect images. In strobe flash mode,
several flashes at a certain flash frequency
are emitted. For this reason, this function is
only possible with a partial light output of
1/8 or less.
For a strobe exposure, the frequency of the
flashes (flashes per second) as well as the
number of flashes must be selected.
Strobe number of flashes (N)
In strobe mode, the number of flashes per
shot (N) can be selected.
The number of flashes can be set from 2 to
90.
+
The maximum possible number of flashes
k
(N) depends on the set partial light output
(P).
Strobe flash frequency (f)
Strobe mode allows you to select the flash
frequency (f), which indicates the number of
flashes per second. The number of flashes
can be set from 1 to 100.
If you desire short flashes, you can manually
reduce the partial light output to the lowest
value of 1/256.
+
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
176
Setting the mode of operation
• Switch on the flash unit with the
button.
The start screen appears. Thereafter, the
flash unit always switches on with the
mode of operation that was used last .
• Press the sensor button of the displayed
TTL
mode of operation on the touch display as
many times as it takes for the display for
0.8 - 9.0 m
selecting the mode of operation to appear.
M-
m
35
Zoom
m
EV
O
MODE
• Press the
M HSS
touch display and select
STROBO
• Press the
REMOTE MASTER
touch display.
p
q
STROBO
• Set a suitable mode of operation on the
M-
3.1m
m
35
Zoom camera, e.g.
m
• Tap the shutter release to transfer data bet-
5 5
N f(Hz)
ween the flash unit and the camera.
P
1/8
sensor buttons on the
STROBO
.
STROBO
sensor button on the
M
.