Metz MECABLITZ 58 AF-2 Canon Bedienungsanleitung Seite 142

Adjusting the settings for slave group C
• Press the key repeatedly until C or C TTL (for slave group C) appears on
Para
the LC display.
• To activate slave group C, press the
slave group C) appears on the LC display. While C TTL is displayed, the
+
keys can be used to adjust the flash exposure correction value for the slave
flash units in group C, from -3 f-stops (EV) to +3 f-stops (EV) in 1/3 increments.
• To deactivate slave group C, press the
appears on the LC display.
• Press to save your settings. If the key
saved automatically after approximately 5 seconds.
The settings for the slave group C are visible only as they are being enter-
ed, as the system does not allow them to appear on the display panel of
the master flash unit after they have been saved.
Setting the remote channel
• Press the key repeatedly until "Ch" flashes on the LC display.
Para
• Set the remote channel using the
• Press to save your settings. If the
saved automatically after approximately 5 seconds.
Setting the zoom position of the reflector
• Press the key repeatedly until "Zoom" appears on the LC display.
Para
• Set the zoom position using the
• Press to save your settings. If the key
be saved automatically after approximately 5 seconds.
Adjusting the settings for the master flash unit
• Press the key repeatedly until M or M TTL (for master flash unit) appears
Para
on the LC display.
142
key repeatedly until C or C TTL (for
Mode
key repeatedly until only C
Mode
is not pressed, the settings will be
– +
and keys.
key is not pressed, the settings will be
+
–
and keys.
is not pressed, the settings will
• To activate the master flash unit, press the
the LC display. While M TTL is displayed, the
to adjust the flash exposure correction value for the slave flash units of group
A, from -3 f-stops (EV) to +3 f-stops (EV) in 1/3 increments.
• To deactivate the master flash unit, press the
–
and
on the LC display.
• Press to save your settings. If the key
be saved automatically after approximately 5 seconds.
Canon manual remote
Adjusting the settings for slave group A
• Press the key repeatedly until A (for slave group A) appears on the LC
Para
display.
• While A is displayed, press the
appears in the display next to the A.
• While A M is displayed, the
tial light output setting for the slave flash units of group A, from 1/1 to 1/128.
Adjusting the settings for slave group B
• Press the key repeatedly until B M (for slave group B) appears on the LC
Para
display.
• While B M is displayed, the
tial light output setting for the slave flash units of group B, from 1/1 to 1/128.
Adjusting the settings for slave group C
• Press the key repeatedly until C or C M (for slave group C) appears on
Para
the LC display.
• To activate slave group C, press the
group C) appears on the LC display. While C M is displayed, the
+
keys can be used to adjust the partial light output setting for the slave
flash units of group C, from 1/1 to 1/128.
key until M TTL appears on
Mode
+
–
and keys can be used
key until only M appears
Mode
is not pressed, the settings will
key repeatedly until M (manual remote)
Mode
– +
and keys can be used to adjust the par-
– +
and keys can be used to adjust the par-
key repeatedly until C M (for slave
Mode
–
and