Troubleshooting - Silvercrest SDI 3500 A1 Bedienungsanleitung

Troubleshooting

PROBLEM
The appliance is not
working. The indicator
light above the ON/OFF
button e fails to come on.
The appliance does not
start the cooking process.
E0 is shown on one of the
displays 0/u.
E2 is shown on one of the
displays 0/u.
E3 is shown on one of the
displays 0/u.
E4 is shown on one of the
displays 0/u.
E5 or E6 is shown on one
of the displays 0/u.
SDI 3500 A1
POSSIBLE CAUSE
The plug is not connected.
The appliance is damaged.
There is no vessel on the
respective hob 1/2.
The vessel is not suitable
for induction hobs.
There is no vessel on the
respective hob 1/2.
The vessel is not suitable for
induction hobs.
The temperature sensor
beneath the hob 1/2 is
defective or there is a short
circuit.
The appliance is being
supplied with too much
voltage (>270 V).
The appliance is not being
supplied with enough voltage
(<150 V).
The appliance has overheated.
POSSIBLE
SOLUTIONS
Connect the appliance to
a mains power socket.
Contact the Customer
Service department.
Place a suitable vessel on
the respective hob 1/2.
Use a suitable vessel
(see the "Suitable
cookware" section).
Place a suitable vessel on
the respective hob 1/2.
Disconnect the plug from
the mains power socket
and contact the Customer
Service department.
Check and ensure that the
appliance is connected
to a properly installed
mains power socket with
220–240 V ~ , 50 Hz.
Check and ensure that the
appliance is connected
to a properly installed
mains power socket with
220–240 V ~ , 50 Hz.
Disconnect the plug from
the mains power socket and
wait until the appliance has
cooled down. If the problem
should persist, please con-
tact Customer Services and
specify the error code.
GB
│ 15 ■