Troubleshooting - Silvercrest SIKP 2000 E3 Bedienungsanleitung

Troubleshooting

PROBLEM
The appliance is not
working. The "On/
Off" indicator lamp
does not light up.
The appliance does
not start the cooking
process.
" "is shown
on the display .
" " is shown
on the display .
" " is shown
on the display .
" " is shown
on the display .
" " is shown
on the display .
" " is shown
on the display .
│ GB │ IE
■ 36
POSSIBLE CAUSE
The plug is not connected.
The appliance is damaged.
There is no pan on the hob
The pan is not suitable for
induction hobs.
The child lock is activated.
There is no pan on the hob
The pan is not suitable for
induction hobs.
The temperature sensor
beneath the hob is defective
or there is a short circuit.
The appliance is being
supplied with too much
voltage (> 270 V).
The appliance is not being
supplied with enough voltage
(< 150 V).
The appliance has overheated.
The electronics have
overheated.
POSSIBLE SOLUTIONS
Connect the appliance to a mains
power socket.
Contact the Customer Service
department.
. Place a suitable pan on the hob
Use a suitable pan (see section
"Suitable cookware").
Press the "+" and "-"
simultaneously for around 3 seconds.
.
Place a suitable pan on the hob
Disconnect the plug from the mains
power socket and contact the
Customer Service department.
Ensure that the appliance is
connected to a properly installed
220 – 240 V ~ , 50/60 Hz mains
power socket.
Ensure that the appliance is
connected to a properly installed
220 – 240 V ~ , 50/60 Hz mains
power socket.
Disconnect the plug from the mains
power socket and wait until the
appliance has cooled down. If the
problem persists, contact the
Customer Service department and
specify the error code.
Check to see whether the fans on
the bottom of the appliance are
working correctly and whether they
can take in a sufficient volume of air.
SIKP 2000 E3
.
button
.