Troubleshooting - Silvercrest SIKP 2000 E2 Bedienungsanleitung

Troubleshooting

PROBLEM
The appliance is not work-
ing. The On/Off indicator
lamp does not light up.
The appliance does not
start the cooking process.
E0 is shown on the
display .
E2 is shown on the
display .
E3 is shown on the
display .
E4 is shown on the
display .
■ 50
GB│MT
│
POSSIBLE
CAUSE
The plug is not connected.
The appliance is damaged.
There is no pot on the hob
The pot is not suitable for
induction hobs.
The child lock is activated.
There is no pot on the hob
The pot is not suitable for
induction hobs.
The temperature sensor be-
neath the hob is defective
or there is a short circuit.
The appliance is being sup-
plied with too much voltage
(>270 V).
The appliance is not being
supplied with enough voltage
(<150 V).
POSSIBLE
SOLUTIONS
Connect the appliance to
a mains power socket.
Contact the Customer
Service department.
Place a suitable pot on the
.
hob .
Use a suitable pot (see
the "Suitable cookware"
section).
Press and hold the child
lock button
approx. 2 seconds.
.
Place a suitable pot on
the hob .
Disconnect the plug from
the mains power socket
and contact the Customer
Service department.
Check and ensure that the
appliance is connected
to a properly installed
mains power socket with
220–240 V ~ , 50/60 Hz.
Check and ensure that the
appliance is connected
to a properly installed
mains power socket with
220–240 V ~ , 50/60 Hz.
SIKP 2000 E2
for