MADRIX PLEXUS Handbuch Seite 97

Columns
In addition, please edit the following columns according to your requirements.
(Perform a double-click to change their values. Use Enter to apply your changes. Use Escape to
cancel.)
'Name' defines the name (label) of the device.
'IP/Subnet' defines the network settings regarding IP address, Subnet mask, and Standard
Gateway for the device.
'Intensity' defines the main brightness of the output your device in percent. Applicable values
are: 0 - 100.
'Speed' defines the tempo of the output in percent. Applicable values are: 1 - 1000.
'Sync' defines if your interfaces, who are in the same Group, use the implemented Master-
Slave Synchronization. Learn more
'Group' assigns your device to a certain group. In this way you may set up several different
Mast-Slave clusters (in the same network). Make sure that Master or Slave devices
that should communicate with each other are assigned to the same group!
'Clock (Date defines the time and date of the device.
- Time)'
Master-Slave Synchronization
Introduction
You may simply connect multiple devices at the same time to control larger LED installations using
multiple DMX universes.
In addition, a master interface can be set up to synchronize the setup across all DMX universes.
This feature is called Master-Slave Synchronization.
© 2011 inoage GmbH
MADRIX PLEXUS User Manual (English)
below .
97
97