Hard Reset - MADRIX PLEXUS Handbuch

The LEDs are not showing any effects!
Please check if the Intensity is set correctly. An Intensity of 0% will leave the LEDs black.
Navigate to the PLEXUS menu 'Stand-Alone'
The Timers are configured correctly in my PLEXUS Configuration. But still they are not
working on the device!
Please go to the PLEXUS menu 'Settings'
The Ports are configured correctly in my PLEXUS Configuration. But still they are not
working on the device!
Please go to the PLEXUS menu 'Settings'
The PLEXUS shows up in the Windows Device Manager. But MADRIX is not able to find the
device!
1) Please check if USB drivers are enabled in MADRIX in the MADRIX Options. 2) Please update
the drivers of the device as described above. This might be necessary after a firmware update.

Hard Reset

Important Information
The following information is to be seen with great caution!
It is only included for your information until you might need it.
There are two button combinations in order to perform hard resets.
Perform a hard reset only when really needed!
© 2011 inoage GmbH
MADRIX PLEXUS User Manual (English)
'Speed/Intensity'.
'Device'. Set 'Timers' to 'Enabled'.
'Device'. Set 'Ports' to 'Enabled'.
115