Sync Mode - MADRIX PLEXUS Handbuch

52 MADRIX PLEXUS User Manual / Handbuch
'Send Broadcast' will send data to all devices in the network.
'Send Direct' will send data only to a specific address.

Sync Mode

An automatic sync mode for Art-Net devices is implemented in MADRIX. In this
way you can activate or deactivate the usage of sync packages.
This Sync Mode is not conform to Art-Net. To work properly it needs to be implemented by
the manufacturer. Please check the manual of your Art-Net node if this option is available to
you.
Before activating sync, make sure that
your network! Else, the frame rate of Art-Net might drop. If you are not sure, do not
enable any sync mode.
Even if your Art-Net hardware does not support Pre Sync or Post Sync mode, it might
be advisable to activate it in MADRIX. In this way, data packages will be sent one
after another and will not get mixed up. The data will be sent more precisely. But
please make sure that all of your interfaces are available in the network.
all activated Art-Net devices are available in
© 2011 inoage GmbH