MADRIX PLEXUS Handbuch Seite 14

14 MADRIX PLEXUS User Manual / Handbuch
Freeze
You may change the settings and the functionality. Press
and hold 'OK' for 2 seconds.
Send on port - Choose between the XLR ports (DMX) and the
Art-Net port (Art-Net).
Send on universe - Choose the first or second DMX universe
(1, 2) or the first or second Art-Net universe (0, 1),
respectively.
Show values as - Choose between decimal values (Decimal),
hexadecimal values (Hexadec.) or percentage values
(Percent).
Test mode - Choose between two modes (Channel,
Universe). Channel allows you to quickly change the DMX
channels, while the value will be saved and stays at the level
you specified. All other channels will be set to 0. Universe
allows you to set up every single channel with different
values. The device will save the value for each channel,
instead of setting them to 0.
Navigate to the menu 'Tools'
You can freeze/halt DMX output on all ports (i.e.
connections) using this menu. This will use and display only
the last frame that was active. Meanwhile, playback or input
may continue. In this way, freeze does not function as
PlayPause.
If you activate Freeze and leave this menu, freeze will still be
active. It will be shown in the menu bar with a blinking icon,
as described above.
Press either , ,
is activated, 'FREEZED' will be displayed.
Press either , ,
output again, 'Running' will be displayed again.
'Freeze'.
, or to halt the output. When freeze
, or a second time to start data
© 2011 inoage GmbH