MADRIX PLEXUS User Manual (English)
101
Group
Call up the PLEXUS Configuration dialog again. Go to the menu 'Tools'
'PLEXUS Configuration '
(or 'Ctrl+Alt+P').
Select your device in the list.
Please configure the column 'Group'!
The setting assigns your device to a certain group. In this way you may set up several different
Mast-Slave clusters (in the same network).
Make sure that Master or Slave devices which should communicate with each other are assigned
to the same group!
PLEXUS Device Settings
Sync
You may check the settings on the device itself.
Navigate to the PLEXUS menu 'Network'
'Sync'.
This menu shows the current settings regarding Master-Slave Synchronization of your current
PLEXUS Configuration.
You can check the Sync type (Master, Slave, Off), Sync group (1 -256), and if Speed (Enabled,
Disabled) and Master (Enabled, Disabled) will be synchronized between the devices.
You may change the settings directly on the device in this menu.
© 2011 inoage GmbH