Adjustment And Safety Devices; Pump Capacity/ Head - Baxi luna platinum+ Gebrauchsanleitung

18. ADJUSTMENT AND SAFETY DEVICES

Safety thermostat
It is forbidden to disable this safety device
NTC fumes probe
heating.
It is forbidden to disable this safety device
Flame ionisation detector
these conditions, the boiler blocks.
Pump post-circulation
The electronically-controlled pump post-circulation function lasts 3 minutes and is enabled, in the heating mode, if the ambient
thermostat causes the main burner to go out.
operate for 10 seconds.
This device is set to 3 bar and is used for the heating circuit. Connect the safety valve to a drain trap. Do not use it to drain the
heating circuit.
In case of a heat demand in the heating mode, the appliance can pre-circulate the pump before the burner is ignited. This pre-

19. PUMP CAPACITY/ HEAD

A high-head pump is used (the chart in annex "SECTION" E
KEY TO PUMP CHARTS - "SECTION" E
Q
RATE OF FLOW
H
HEAD
MIN Minimum speed of modulation
MAX
Maximum speed of modulation
7219836.01 (1-04/15) 52