Connecting To A Zone System - Baxi luna platinum+ Gebrauchsanleitung

B) FLOW TEMPERATURE MODULATION
Access menu 2.
B Temps / mode CH1
B
If, when turning the knob B
temperature, parameter 742 has not been set correctly.
Access menu 2 as indicated at the beginning of this section.
B
B Yes then B
ADJUSTING THE TEMPERATURE OF THE HIGH TEMPERATURE HEATING SYSTEM
To avoid frequent starting and stopping, raise the minimum temperature setpoint of the boiler in the heating mode by setting
parameters 740
TEMPERATURE ADJUSTMENT ON LOW TEMPERATURE HEATING SYSTEM
parameter 741 (point B)

14.3 CONNECTING TO A ZONE SYSTEM

KEY TO ELECTRICAL CONNECTIONS (see diagram A in annex "SECTION" F at the end of this manual).
Z Zone (1..n) EV Zone electrovalve
R Relay RT Room thermostat
ambient thermostats can be used to control the other zones.
SYSTEM CONNECTIONS
Connect the zone 1 valve/pump to terminals 6-7 of terminal block M3, as described in section 14.
Connect the Ambient Thermostat contact of the other zones to terminals 1-2 of terminal block M1.
CONFIGURING PARAMETERS
Access menu 2 as described in section 14.2.1.
B Operator unit
B Temps / mode CH1
C to return to the previous menu then
B 5715 (Temps / mode CH2)
B
B Room thermostat CH2
C to return to the previous menu and then
B to the maximum electrovalve open time (expressed in seconds) and then
7219836.01 (1-04/15)
742
B B
"---" then B
B B
B B
B
B
B to On
5977 (Function input H5) then
B
B
742
6200 then B.
B.
42 B
B
B
Temps / mode CH1
46
B
B B 746 B
B