Single Splitting Kit (Alternative Accessory); Electrical Connections; Connecting The Room Thermostat - Baxi luna platinum+ Gebrauchsanleitung

SINGLE SPLITTING KIT
For special installations of the fumes inlet/outlet ducts, the
single splitting kit (C), supplied as an accessory, can be
used. This accessory, in fact, can be used to move the inlet
and outlet in any direction. This type of installation makes
it possible to discharge exhaust fumes both outside the
"SECTION" D

14. ELECTRICAL CONNECTIONS

Live-Neutral polarity.
fuse carrier).
safety cover.
TERMINAL BLOCK M1 (observe the polarity L - N)
(L)
(N) Neutral (light blue).
Earth
(1) (2) Room Thermostat.
TERMINAL BLOCK M2
(supplied as an accessory).
Terminals 6 - 5 (common 2nd Auxiliary Probe (probes for
solar plant, cascade system, etc.).
solar plant, cascade system, etc.).
not used.
connection of the DHW boiler probe (for
heating only boilers).
TERMINAL BLOCK M3
Terminals 1...5: not used.
Terminals 6 - 7: Multifunction relay contact (e.g.: zone system section 14.3).

14.1 CONNECTING THE ROOM THERMOSTAT

access the terminal block M1;
remove the jumper from the ends of contacts 1-2
Put back the jumper on terminals 1-2 of boiler terminal block M1 if the ambient thermostat is not used or if the wall-mounted
Control panel is installed (section 14.2).
7219836.01 (1-04/15)
) - 2 (earth) - 3 (+12V connection
External Probe connection
1st Auxiliary Probe (probes for
M1 and M2, used for the electrical connections, by removing the
44