Maintenance And Cleaning; Disposal - TOOLCRAFT ST-100HF Bedienungsanleitung

14. Maintenance and cleaning

• The soldering station is maintenance-free, except for the occasional replacement of the soldering tip, sponge and
fuse. Servicing and repair work must be done by a technician.
• Before cleaning the soldering station, disconnect it from the mains and remove the mains plug from the mains
socket.
• Allow the soldering iron and soldering station to cool down completely.
• Use a clean, soft and dry cloth to clean the exterior of the soldering station.
• Never use aggressive detergents or other chemical solutions, as these may damage the housing (discolourations)
or cause the product to malfunction.
• The soldering tip does not require any special cleaning. It is sufficient to clean it occasionally by using the wet
sponge or dry metal cleaner to remove flux residues and excessive solder.
• The soldering tip must be coated with tin before the soldering station is switched off. This prevents corrosion on the
soldering tip and prolongs its lifespan.

15. Disposal

Electronic devices are recyclable waste and must not be placed in household waste. At the end of its
service life, dispose of the product according to the relevant statutory regulations.
49