B) Programming A Fixed Soldering Tip Temperature - TOOLCRAFT ST-100HF Bedienungsanleitung

b) Programming a fixed soldering tip temperature

• Enable settings mode as described in section 10. a).
If you have not set a password or have not changed the default password ("000"), you must first set a
password (see section 10. e). If the password is set to "000", you will not be able to set a fixed soldering tip
temperature.
• Press button "1" when the main menu is displayed. If the password is set to "000", "SET PASS FIRST!" will appear
for a few seconds, and then the main menu will be displayed. Change the password (see section 10. e).
• "SET TEMP." will appear briefly on the display.
"ENT.PASS 000" will be displayed.
• Use the three control buttons (2) to enter the password.
"1" = Decrease value
"2" = Choose input position
"3" = Increase value
• Hold down button "2" to confirm your entry. The password will flash three times and "SET TEMP 000" will be
displayed.
• Enter the desired soldering tip temperature using the three control buttons (2).
"1" = Decrease value
"2" = Choose input position
"3" = Increase value
• Hold down button "2" to confirm your entry. The soldering tip temperature will flash three times and "SET TEMP
SUCCESS" will be displayed (= temperature was successfully set).
• The display will revert to the main menu after a few seconds (see screenshot in section 10. a). To exit settings
mode, switch the soldering station off using the on/off switch.
The soldering station will automatically heat to the preset soldering tip temperature when it is switched back
on. The temperature cannot be changed using the control buttons (2) or the temperature control dial (7).
You can use this function when you plan to use the soldering station in a production facility and do not want
other users to change the temperature.
To disable this mode, refer to the instructions in the next section (section c).
40