Setup Location - TOOLCRAFT ST-100HF Bedienungsanleitung

• Never touch the power adapter or the mains cable when your hands are damp or wet, as this may cause
a fatal electric shock!
• Do not touch the mains cable or the soldering station if there are any signs of damage, as this may cause
a fatal electric shock!
Switch off the mains voltage to the socket containing the power adapter (switch off at the corresponding
circuit breaker or remove the fuse, and then switch off at the corresponding RCD protective switch).
You can then unplug the power adapter from the mains socket.
• If the fuse is defective, replace it with a new fuse with the same specifications (type, voltage, rated cur-
rent, trip characteristics). Never bridge a defective fuse, as this may cause a fire or a fatal electric shock.
• Check the product for any signs of damage before each use. If there are any signs of damage, discon-
tinue use immediately. Take the product to a specialist repair centre or dispose of it in an environmentally
friendly manner. If the mains cable is damaged, it must be replaced by a new mains cable with the same
specifications.
c) Setup location
• The soldering station must only be used in dry, enclosed indoor areas. It must not become damp or wet.
Moisture on the mains cable/power adapter or in the soldering station may cause a fatal electric shock!
Important:
The base of the soldering iron holder features a small container that you can use to store the metal
cleaner or wet cleaning sponge. The wet cleaning sponge must be dampened with water. You can then
use the sponge to remove flux residue from the hot soldering tip. Never immerse the soldering tip or the
soldering iron in water.
When moistening the sponge, ensure that water does not drip into the soldering station or onto the
soldering iron.
• Avoid direct sunlight, intense heat and cold temperatures. Keep the soldering station away from dust
and dirt.
• Place the soldering station on clean, level surface of a sufficient size. Do not place the soldering station
on flammable materials (e.g. a carpet or tablecloth). Always use a non-flammable, heatproof surface.
• Keep the soldering station away from flammable or combustible materials (e.g. curtains).
• Never cover the product, as this may cause it to overheat and catch fire. Ensure that there is sufficient
ventilation when the soldering station is in use.
• Never insert objects into the ventilation holes on the soldering station, as this can cause a fatal electric
shock.
• To prevent scratch/burn marks and discolouration, always use suitable protection when placing the
charger on valuable furniture.
• The product must be installed, used and stored out of the reach of children. Children must be supervised
to ensure they do not play with the product. Burn hazard!
• Do not use the product in the immediate vicinity of strong magnetic/electromagnetic fields, transmitter
aerials or HF generators. These may affect the electronic control system.
• Make sure that the cables are not pinched or damaged by sharp edges. Do not place any objects on
the cables.
31